removing the immobilizer shouldnt prevent the car to start. It will just throw a cel. Since yours runs without these two wires connected, im going to leave them alone and start troubleshooting the motor side. Do you mean jumping the starter?
Appreciate any pics on how you wired the cluster.
Yes i do have the clutch safety switch wired and checked to make sure they are secure including the ground. Did what you did, blue\white wire on the driver side panel and blue\white wire on the switch run to pin 17. Before i wired it like this, the motor wouldnt even turn. After i wired the...
Hello Varnell, question for you on this swap. Did you have to connect the VCC3 and SG3 wires to get it to start? i have followed your wiring diagram and everything is done except for these two wires. Not sure where to splice them in. When i turn the key, the motor turns over but doesnt turn on...
Hello, varnell. I saw you put up a link to the j32a2 ecu wiring diagram. When i click on it, it doesnt open for me. Can you maybe email them to me? Been looking on a bunch of forums like j32a.com and acurazine with no luck. Thank you
I click on the J32a2 6mt ecu wiring link but it says the page has been moved. Am i doing it wrong? im so close to being done im starting to dream about it lol.
take a bunch of pics. im starting to put mine together but forgot where some of the parts and hoses go to. haha and the wiring is a PITA. still trying to find ecu pinouts