We boost leak test up to 30psi at the shop with everything attached. Check your injector seals, couplers, throttle body and etc for leaks. Nothing should leak if it is done correctly.
What line is leaking on the fpr? Do you have zip ties on your vacuum lines?
Have you done a boost leak test yet? Also just about every hks bov ive seen the vacuum nipple pops out. Doesn't hurt performance. Just reattach it. If you actually want a better bov upgrade to a tial.
Meet is not supposed to be posted on Houston-Imports. Thanks for your co-operation.
Where: F.I.S.T-Racing / Collins automotive
11814 Champion Forest Dr Houston Tx 77338
When: March 8th. 12pm-6pm
Who: Accords of all generations.
Why: Good times
Rules:
1) Bring us Alcohol. Coolers will be set...
I don't like to talk about the cost. It was done for fun. :waytogo:
Prolly saved 40lbs from the stock crossmember. Works great don't have anymore wheel hop.
I'm not using a front motor mount at this time. Just using a solid innovative rear mount. The traction bar doesn't have a spot to...
Yes the valve cover and brake setup is hydro dipped. Here is a pic of my Brembo BBK setup. Work was done by houtson hydro dip. They do great work.
The clutch works great. I like it. Should hold up fine for my goals. Looking to push 400whp once I get all the kinks worked out and install my...
Oops fixed the typo.lol. No reason why I chose it over anything else. Sold my h22 turbo manifold a while back. So made this since its what I had laying around.
Having fun with the car. Just need to get it up on the dyno and finish tuning it for some numbers. Hope you have enjoyed the thread. That is all.
Accord antilag vid
Waiting on my clutch to arrive then I'll be dropping it in and firing her up. :D
Rebuilding my h22 trans and installing lx 5th gear. Had a surprise on the inside I wasn't expecting.
The case was tore up pretty good and one of countershaft...
Back under the knife.
Prepping the new motor. File fitting the rings to my new specs.
New engine build sheet:
f23a1 87mm destroker.
h22 crank
eagle rods
mahle pistons. compression comes out to 10:2-1. Perfect. :D
Balance shaft delete kit
ACT 10lb flywheel
Ported...
Mocking up the piping. 3" cold side piping and 2.5" hot side piping. Tial 50mm BOV.
Making my oil feed line setup.
Installing my tapped oil pan from my last turbo setup.
Oil return line.
Starting to finish everything up.
FIC 650cc...
Did this build on my car in just a couple weeks time. The car was already f23 turbo before the build. Put down 280hp/340ft lbs of tq before I spun a rod bearing on the stock motor. Then decided to build it. Figured since it was an f23 build you guys might enjoy it.
This will cover the turbo...
Re: RL Caliper Mounting Brackets | ION Lenses/Headlights Or Clear Lenses/Headlights
Might want to give these a shot. Brackets might work the same for your car.
http://fatfourcustoms.com/newest_products/94-97_honda_accord