thanks for the compliments, there is tons to still do on it but time and money will not be devoted to it any time soon. Hopefully by next spring i finish my other cars and then finish this one.
I won't be selling any of my cars because im still young and my money goes to either my cars or any...
I like to call this project dead cause i've decided to buy a 240sx which i did and motor swap it... then buy a lexus sc300 all by this year, so my accord is not going to be touched anymore :(
Still love my accord and support the scene so i think im gona upload a few DIY's so look out for those...
looks nice man, whats ur opinion, what was the best performance car out of you past cars you had, personally im going from honda to nissan. whats your opinion
This is also from darkside a little more info on the exhaust he has and his thoughts. So to me it looks like a 50/50... you get one thing but lose the other.
2. GREDDY SP CATBACK SYSTEM
Next was the catback muffler. Greddy was a brand I trusted and went ahead and bought a Greddy SP catback...
personally to tell you the truth getting a deep tone on a 4 banger is very difficult. If I were you get something that you believe looks good and you know is not to loud. I don't think your going to get the deep tone you want on your four banger.... I have a bunch of buddies going for the same...
AEM intakes are painted with a heat resistant coating.... u can buy this stuff at any local hardware store, so if u got a cheap ebay intake, mite as well paint it with some heat resistant paint. Same principle as the wrap just another way
:( Ok basicly with a test pipe u gain hp but u loose torque.... with a High Flow Cat you gain torque but lose hp. Here is an example with numbers.
Test Pipe= 10hp & 5lbs
Cat= 9hp & 7lbs
Im to lazy to go find sources, but im sure there is people on here that know this and will tell u the...
Where can i get this fast drying Epoxy? Home Dept, Home Hardware, Sears, Canadian Tire....
Im assuming anywhere but trying to save my self the time of driving around
Has any used the epoxy, apperently it takes some time to dry and needs to be held in place. So this mite be akward
With the screws if the mesh holes is bigger then the screw what did u do. Im kinda stuck because i don't want the screw to be showing on teh front and im assuming u screw it in...
how do u install the mesh/chicken wire on a body kit.... i need to install it on my front bumper and not sure how exactly to do it. I could figure a way out but i rather know the correct way.