hotaccord243
Well-Known Member
Re: Going for a re-tune....
Thanks! I was so relieved... thanks for the help btw!
Why you having some problems with your motor?
BTW, got my head, IM gasket, and IM attached, IC piping back on and hoses/clips attached all tonight. Torqued per manufacture specs on the head, set the head and bottom end to TDC. Sorry for the crappy pic, took on my blackberry...
Tomorrow I should be picking up the Crank pulley holder tool from AutoZone (had to order) and get back to work tomorrow or Wed. to disassemble the timing belt cover and make sure everything is at top dead center and re-attach the belt. Also check valve clearances, install turbo, fill it up with coolant and bleed, and fill oil and turn it over finally.... Also hope to sweet lord that there are no exhaust/oil/coolant leaks... ugh.
Congrats on getting that POS outta there bro!
Thanks! I was so relieved... thanks for the help btw!
BadgerType said:i fear what my cylindars look like.......
Why you having some problems with your motor?
BTW, got my head, IM gasket, and IM attached, IC piping back on and hoses/clips attached all tonight. Torqued per manufacture specs on the head, set the head and bottom end to TDC. Sorry for the crappy pic, took on my blackberry...
Tomorrow I should be picking up the Crank pulley holder tool from AutoZone (had to order) and get back to work tomorrow or Wed. to disassemble the timing belt cover and make sure everything is at top dead center and re-attach the belt. Also check valve clearances, install turbo, fill it up with coolant and bleed, and fill oil and turn it over finally.... Also hope to sweet lord that there are no exhaust/oil/coolant leaks... ugh.