Here's my DIY thread on how to remove the door panels.
http://www.6thgenaccord.com/forums/showthread.php?t=43803
Just follow the steps 1 ~ 12. After removing all of the screws, all you gotta do is pry off the panel with your hand vigorously. (Be brave, it will come off.)
I'm sure you'll have no trouble working on it, if you follow my steps.
Cut out more than you need, and stick it to the flat surface first. Then get a hairdryer or heat gun and heat the vinyl where you're gonna put it around curves. Then stretch and pull it down, like putting plastic wrap around a plate of food.wrapped my centre console a few weeks ago. I now just need to do my heated seat bezel, but I have a feeling the angles and curves will make it difficult. Anyone have any experience?
Cut out more than you need, and stick it to the flat surface first. Then get a hairdryer or heat gun and heat the vinyl where you're gonna put it around curves. Then stretch and pull it down, like putting plastic wrap around a plate of food.
I did a computer mouse like that.
