Good Header and intake manifold.

[GrubbyHonda]

what is a good header and intake manifold for the f23a4?

[BlkCurrantKord]

There is no aftermarket intake manifold avail. You could always find a spare oem one and have it gasket matched and ported a little.

Header - DC sports (if they're still around) or just go ebay

[GrubbyHonda]

Originally Posted by BlkCurrantKord There is no aftermarket intake manifold avail. You could always find a spare oem one and have it gasket matched and ported a little. Header - DC sports (if they're still around) or just go ebay

how much of a pain is it to swap in an f20b. i dont care if its auto to be honest. cant i use my current auto f23a4 trans. i just want a healthier fresher motor.

[BlkCurrantKord]

Read some of the writeups on H22 swaps. It's quite literally the same engine.

[Enne]

I think Megan Racing also makes a header for the F23A4 IIRC. Have you cleaned your intake recently or at all? I saw a photo of one the other day that was removed and cleaned, and holy scheiß was it dirty.

[GrubbyHonda]

do the flex pipes on these tend to crap out and cause a huge leak?

[Nam1911a1]

Not sure about the flex pipes. My 98 has 220k miles and the flex pipe is still good. A little dented from being lowered but still good. My 95 Camry had the flex pipe break but I still drove it and sold it. The flex pipe only broke because the motor mounts were shot and caused excessive movement and vibration that over stressed the flex pipe. I used to run that thing hard. It lived at 6k rpm every day for years.