selttijcmanit
Active Member
So quite a few people are aware that the distributor on the 98-02 F23A1 is non-adjustable, it has two bolt holes and both are too narrow to spin the distributor a meaningful amount. However that begs the question; if I were to mill larger slots where the holes are to make it adjustable, would it work? It's more a question of whether the computer can tell that you've made the adjustment or not..
I'm looking to pull about 6 degrees but I want to know what you guys think.
Shanks in advance
I'm looking to pull about 6 degrees but I want to know what you guys think.
Shanks in advance