How to change power steering belt
- Thread starter drey
- Start date
nhoz22
Well-Known Member
http://www.ehow.com/how_12150776_remove-power-steering-belt-98-accord.html
Sent from my SGH-T999 using Tapatalk 2
Sent from my SGH-T999 using Tapatalk 2
001Stunna
Well-Known Member
-Loosen the power steering pump mounting bolt (A) and pump lock bolt (B).
-Remove old belt and put on new belt, making sure it fits over the teeth of the pulley(s)
-Adjust the belt tension by moving the power steering pump with a 1/2" drive breaker bar to obtain the proper belt tension, then retighten the mounting bolt and lock bolt.
-Start the engine and turn the steering wheel from lock-to-lock several times, then stop the engine and recheck the tension of the belt.
-Remove old belt and put on new belt, making sure it fits over the teeth of the pulley(s)
-Adjust the belt tension by moving the power steering pump with a 1/2" drive breaker bar to obtain the proper belt tension, then retighten the mounting bolt and lock bolt.
-Start the engine and turn the steering wheel from lock-to-lock several times, then stop the engine and recheck the tension of the belt.
001Stunna
Well-Known Member
Thanks Stunna! That was one of the easiest DIYs...lol
....however I broke the tension bolt
HOw???? Did you replace it already i hope?
tegpower18
Active Member
pb blast is your friend in situations like this. If anything looks even questionable I soak it with pb blast for a couple days then when Im ready to do the job again It is hopefully worked loose.
