Mikenguyencf
Member
Re: Projekt G23[Hold] | [Current] Euro r H22A
good luck man excited to see the results!!
good luck man excited to see the results!!
Projekt G23[Rebooted] | [Ended] Euro r H22A
- Thread starter TheEdge
- Start date
TheEdge
Well-Known Member
Re: Projekt G23[Hold] | [Current] Euro r H22A
Had to replace my intermediate shaft to use accord axles.
Had to replace my intermediate shaft to use accord axles.
TheEdge
Well-Known Member
Re: Projekt G23[Hold] | [Current] Euro r H22A
My adapter plate to use with throttle cable.
Distance between holes on the corner is 5in.
My adapter plate to use with throttle cable.
Distance between holes on the corner is 5in.
TheEdge
Well-Known Member
Re: Projekt G23[Hold] | [Current] Euro r H22A
Finished replacing my lower ball joints and was feeling eager to start the engine up. In my hurry I forgot to clamp the lower radiator hose and found out about it revving around 5k. Feel like a dumb idiot. Made a mess on garage floor.
Finished replacing my lower ball joints and was feeling eager to start the engine up. In my hurry I forgot to clamp the lower radiator hose and found out about it revving around 5k. Feel like a dumb idiot. Made a mess on garage floor.
TheEdge
Well-Known Member
Re: Projekt G23[Hold] | [Current] Euro r H22A
Took it out on st for test drive.
Took it out on st for test drive.
danmccormick87
Well-Known Member
Re: Projekt G23[Hold] | [Current] Euro r H22A
That's pure awesomeness right there, but honestly, I'd switch out to a half-core radiator with a pusher fan and a puller fan, and build a heat shroud to keep the header heat away from the radiator... Also give you room for a future turbo build
That's pure awesomeness right there, but honestly, I'd switch out to a half-core radiator with a pusher fan and a puller fan, and build a heat shroud to keep the header heat away from the radiator... Also give you room for a future turbo build
TheEdge
Well-Known Member
Re: Projekt G23[Hold] | [Current] Euro r H22A
Well for my first swap it was easy choice. With turbo build I will have to follow your suggestion for the extra room.
Well for my first swap it was easy choice. With turbo build I will have to follow your suggestion for the extra room.
TheEdge
Well-Known Member
Re: Projekt G23[Hold] | [Current] Euro r H22A
Bolted down my radiator support. Did use lock nuts overs thread lock.
Bolted down my radiator support. Did use lock nuts overs thread lock.
HonDoc
Member
Re: Projekt G23[Hold] | [Current] Euro r H22A
This is a great thread, nice pics and descriptions. Answered a lot of little questions i had with this build. Can't wait to see how it all turns out! keep it up man.
This is a great thread, nice pics and descriptions. Answered a lot of little questions i had with this build. Can't wait to see how it all turns out! keep it up man.
TheEdge
Well-Known Member
Re: Projekt G23[Hold] | [Current] Euro r H22A
Finally made my radiator stays from 2 angle iron pieces.
Drilled one side with a hole for rubber grommet. Other sides are slots for
depth and distance adjustment. Crude but sturdy. V1 has to be ugly
Finally made my radiator stays from 2 angle iron pieces.
Drilled one side with a hole for rubber grommet. Other sides are slots for
depth and distance adjustment. Crude but sturdy. V1 has to be ugly
