Engine:
3.2l obdII
3.5in Conforti Cold Air intake
3.5in Dinan mass air flow meter
Dinan3.5in to 3in to an ASC delete intake boot
Dinan Throttle body
Eurosport M50 manifold conversion kit
TRM ecu flash for manifold/3.5in intake components
Mahle Fuel Filter
New 140 amp Bosch alternator
New OE engine mounts
Doctor Vanos Stage 2 rebuilt vanos unit
Turner Motorsport Underdrive Pulleys
Transmission:
Brand New OE Clutch, pressure plate, and Throwout bearing
UUC EvoIII short shifter
Guibo/Flex Disk
New master cylinder w/ UUC clutch pedal arm bushings
UUC Rob Knob II SE with motorsport 5 speed insert
Suspension/Steering
Ground Control Track School Coilovers with 525/650r springs
Corner balanced and aligned to perfection.
Adjustable swaybar endlinks
Lemforder front lower control arms
Lemforder LCA bushings
Lemforder inner and outer tie-rods
New OE steering rack
New OE pump
PS reservoir, feed line to pump, return line from rack to reservoir
Vorshlag camberplates
68k mi. Factory M3 steering wheel w/ slip ring
bearing behind the steering wheel
Reinforced rear trailing arm pockets with the Bimmerworld kit
UUC rear trailing arm bushings
UUC adjustable chromoly rear control arms
Rear wheel bearings
Reinforced rear swaybar tabs
UUC subframe bushings
Ground Control reinforced rear shock mounts
UUC braided stainless steel brake lines
ATE SuperBlue Brake fluid
TMS Adjustable sway bar links both fronts and rears
TMS Sway bar set 30mm adjustable front and 24mm adjustable rear
UUC Trans mount
UUC TRANSMISSION MOUNT
Exterior:
12mm spacer up front
90mm wheel studs and nuts
DEPO european ellipsoid projector headlights with clean install
6000k HIDs with small ballasts mounted to the back of the headlights
Fog light delete covers
Smoked front turn signal markers, side markers, and rear tail lights
Shadowlined kidney grills
New hood roundel and carbonfiber trunk roundel
Freshly painted black M3 door moldings with Motorsport International insert
OEM DS1 wheels stamped with the BMW MOTORSPORT
Interior
Black Vaders with 68k miles
New window regulator and motor for driver side
Carbon fiber guage cluster with chrome rings
Again, the UUC RKII shift knob and matching ebrake handle
Kirk 4pt cage
Setup for quick install of 6pt harnesses
Microfiber headliner, pillars and deck
The day I picked it up 4-28-13
Pics of the interior
This is by far my favorite part of the car
Cleaned the car up a little
