18x9.5 +14 squared set up questions

b1L@L

Well-Known Member
Joined
Nov 18, 2008
Posts
361
Reaction score
1
Location
Niagara Falls, Ontario
Hey guys,

I am about to finally pull the plug and do a 5 lug conversion.
Question I have is regarding the new wheels I will be putting on and what exactly I will need to make this happen.

Here are the specs of the wheels I am planning to run on the car.
18x9.5 +14 squared set up

I will have all the fenders rolled and slightly pulled.

For those who ran similar specs, can you please let me know if you used camber kit for the front and rear or was natural camber enough?

If camber kit required, which ones would you recommend.

Here is my car below and my new wheels:


 
Last edited:

SykVSyx

Well-Known Member
Joined
Jan 6, 2007
Posts
13,938
Reaction score
30
Location
Tee Dot Ohh
Bout time you stepped up to the 5 lug 'game'.

Perhaps look in to this,

Ingalls/SPC camber kits

The fronts are 39207 and 39208 and the rears are 67090 two of those. Front are ingalls and rears are spc
 

ThatDesiKid

Well-Known Member
Joined
May 31, 2015
Posts
175
Reaction score
17
Location
Rochester Hills, Michigan
You should check out @colombia_21's member's ride page. He ran a similar set up you are looking to run except on a sedan. He also used 5mm spacers so I think he was at +20 offset? His ride thread also says he used a wicked tuning rear camber kit. Congrats on the Equips! It's gonna make the car look even more mad!
 
Back
Top