The entire projector. These are made for them. The shrouds are not in on the pictures. I have to trim them to fit our headlamps.yeah, what about the light leaking out of the projector? with "sealed" projectors, looking at the headlamp...all you see is the circle of light and its niiiice
edit: how much of the projector will those cover?
you could just replace the h1 bulbOh ok, that's great then. Also, I'm currently using a Raptor 9006 HID kit and I know this is a stupid question, but can I just replace the 9006 bulb with a H1 bulb or would I need a new kit?
Yes snap on. However they are too big for our housing so you either have to trim the shroud or trim the bottom of the reflector. I tried trimming the shroud but by the time you took enough off the shroud is way too flimsy, I ended up snapping one so for the time being I'm running shroudless until I get more time to pull the headlamps back apart.so i assume they snap on or do they have to be JB'd on?
Yeah you just need to replace the 9006 with an H1. You will more than likely need to trim the H1 bulbs to fir into the holder. I know I had to with my DDM H1's.Oh ok, that's great then. Also, I'm currently using a Raptor 9006 HID kit and I know this is a stupid question, but can I just replace the 9006 bulb with a H1 bulb or would I need a new kit?