car wont start,AEM EMS installed
- Thread starter 1NonlyAccord
- Start date
1NonlyAccord
Well-Known Member
After reading a bit about stat sync'd, what it is, is the ECU check to make sure that the signal between the crank position sensor and the cam position sensor agree with each other. It should be off at stand still, but when cranking it should turn on....does it do this?
1NonlyAccord
Well-Known Member
Im not sure.Im back inside. I wanted to get a few ideas to go try before going back out there
1NonlyAccord
Well-Known Member
I do have the bisimoto stage2 turbo cam.adj cam gear installed..idk if that makes a difference.
I think i found the issue. Fixing it now. They renamed a bunch of parameters between the series 1 ems and the series 2. Finding and converting everything is a PITA. I did all the tables and correction factors, but it turns out they also remapped the cam/crank position stuff. taking care of that now...and the fire should fire up.
1NonlyAccord
Well-Known Member
Going out now with the last map,going to do the setup wizard like stated as well
