1990 Parts swap?!

Hey!
I know if i search i will find out this, but i don't have a lot of time. i just need to make sure all these parts will swap over to my car without too much hastle. i have found i 1990 accord with a manual in it. It's been sitting outside for two years at a junkyard i believe. clutch is bad or something. I can probably get all the parts i need for around 300 or 400 dollars.

CG ONLY Parts
• F23 Brake Pedal
• 98-00 or 01-02 MT ECU
• F23 Driver side Axle
• F23 Shifter
• F23 Manual tranny bracket
• F23 Manual tranny Mount
Any Prelude or Accord Parts (F/H Series)
• Manual Transmission Complete
• Clutch
• Flywheel
• 5 speed starter (90-02 Accord 92-02 Prelude)
• Clutch line from Clutch dampener to 5 speed tranny
• Clutch line from Clutch master cylinder to clutch dampener
• Clutch Pedal Complete
• Slave cylinder
• Clutch line from 5 speed tranny to slave cylinder
• Clutch master cylinder w/ reservoir and lines
• Shifter Cables
• Shift Boot
• Shift Knob
• Intermediate shaft
• Your Tranny/Year Starter
• Nuts and washers for shifter
• shift fork for clutch
• year/tranny flywheel
• nuts, washers and cotter pins for shifter cables
• couple of thick washers for the master cylinder
• clutch fluid reservoir and mount with bolts
• nut and bolt for master cylinder/pedal connection
• 6 pressure plate bolts
• 8 Flywheel bolts
• 2 nuts for master cylinder
• 3 C clips
• 1 long tranny bolt
• 1 long starter bolt
• 3 bolts for intermediate shaft
• year/tranny reverse sensor and wiring
• year/tranny VSS and wiring

Parts in red i already have. im mainly worried about all the clutch lines not being right. i was told that they have changed from generation to generation. I plan on going to get these parts tomorrow since i don't work. Oh and this is for a manual swap in a 2002 accord. Thank you for your help in advance!!

A LOT of that stuff will be different. Things like pedals and shifters and stuff are almost universal but cables, lines, shafts and things like that will be different. You can get them and try them but dont put all your eggs in that basket...

Alright. i doubt they will cost much so ill probly pull them. Tranny, starter, bolts, cotter pins, washers, pedal. Those should fit? Any special tools that im going to want to take for this job? i plan on taking all my sockets and wrenches and propane. any others?

Oviously, things like bolts and washers and stuff are universal. Make sure you have extensions of all lengths and sizes. Im always overlooking mine and end up needing it, lol.

Alright Thanks Mikey! Hopefully soon i'll grow a fifth gear!! lol