lashlee
Well-Known Member
Let me first say sorry to those that were interested, I completely forgot that I posted this on here, and haven’t been on here since I posted it. With that being said, here’s the specs:
2-12” subwoofer enclosure made for Image Dynamics IDQ12V3D4 subs (not included). The subs are setup with hurricane nuts so that machine screws hold the subs down. The holes were cut to fit these subs and may not exactly fit other subs. A quick look into the specs of the ID’s versus what you have will give you an idea if you will need to cut the mounting baffle to fit. There is a diagonal crossbrace under the baffle to add strength. The enclosure was made to fit a 98 4 door and may fit a 2 door. I had Raammat under the box (and in between some of the layers of fiberglass) and that should give you a little wiggle room if the floor pan is slightly different. The enclosure was designed to fit around my amps, thus the odd shape of the mounting baffle. The baffle itself is covered in formica, and could be removed/replaced if the new owner wishes to. The trim panels/amp pans are setup for my Xtant amps, and covered in the same formica/carpet. There are breathable grills for the three amps. This raises the floor approximately 3-4” and includes panels to make everything slip together, including a cover for the area where the seat back folds down. I would rather this be a local pick at my house in Knoxville, TN due to the way it goes together and the overall size would make it difficult to ship. If you want to contact a shipper, and handle the leg work, that’s up to you but I’m not sure it would be worth the effort. In short, I hate to throw this away but I’ve sold the car and really would rather this go to a good home.
I also have a set of kick panels made for a Dynaudio MW160 if interested.
2-12” subwoofer enclosure made for Image Dynamics IDQ12V3D4 subs (not included). The subs are setup with hurricane nuts so that machine screws hold the subs down. The holes were cut to fit these subs and may not exactly fit other subs. A quick look into the specs of the ID’s versus what you have will give you an idea if you will need to cut the mounting baffle to fit. There is a diagonal crossbrace under the baffle to add strength. The enclosure was made to fit a 98 4 door and may fit a 2 door. I had Raammat under the box (and in between some of the layers of fiberglass) and that should give you a little wiggle room if the floor pan is slightly different. The enclosure was designed to fit around my amps, thus the odd shape of the mounting baffle. The baffle itself is covered in formica, and could be removed/replaced if the new owner wishes to. The trim panels/amp pans are setup for my Xtant amps, and covered in the same formica/carpet. There are breathable grills for the three amps. This raises the floor approximately 3-4” and includes panels to make everything slip together, including a cover for the area where the seat back folds down. I would rather this be a local pick at my house in Knoxville, TN due to the way it goes together and the overall size would make it difficult to ship. If you want to contact a shipper, and handle the leg work, that’s up to you but I’m not sure it would be worth the effort. In short, I hate to throw this away but I’ve sold the car and really would rather this go to a good home.
I also have a set of kick panels made for a Dynaudio MW160 if interested.
