Nam1911a1
Well-Known Member
So I had some down time at work today. Been having the idea of making my own custom weighted shift knob for a while now just didn't have time at work to do it.
It's a pretty simple idea. A 3/4 rigid couple with two rows of three 3/8" bolt set screws offset of each other as a means to attatch to the factory shift lever. Then a close nipple and a 1"-3/4" reducer to a 1" coupling and two 1" pipe plugs which are solid steel.
I'm chopping a few inches off the factory lever to make a "short shifter".
Yea go ahead and tell me it's ghetto but I don't care and it's gonna look cool and custom.
It's a pretty simple idea. A 3/4 rigid couple with two rows of three 3/8" bolt set screws offset of each other as a means to attatch to the factory shift lever. Then a close nipple and a 1"-3/4" reducer to a 1" coupling and two 1" pipe plugs which are solid steel.
I'm chopping a few inches off the factory lever to make a "short shifter".
Yea go ahead and tell me it's ghetto but I don't care and it's gonna look cool and custom.