Question for my f20b swapped people

lmayoral2191

Well-Known Member
Joined
Mar 31, 2014
Posts
53
Reaction score
0
Location
kansas city
I’m working on the distributor wiring right now, I’ve extended the wires from the ckp to the new distributor connector. My question is there is 9 wires on my f20b plug in, I only have 8 on my factory accord harness. I keep getting a code 9 on Hondata for cyp... anyone ever dealed with this issue?
 

Student005

Active Member
Joined
Feb 5, 2018
Posts
36
Reaction score
0
Location
Eau Gallie, FL
I have never done that exact swap but when I swapped a B series into my EF I encountered a similar issue. I had to find the pinouts for the ECU I was using (P72 in my case) and the pinouts for the plug on the dizzy I was using (97 teggy in my case) and make sure all my wiring from the dizzy had continuity to the correct locations at the ECU. It’s a major PITA but when that baby fired up I felt like Dr. Frankenstein

Sorry don’t have no better info but I hope that helps
 

lmayoral2191

Well-Known Member
Joined
Mar 31, 2014
Posts
53
Reaction score
0
Location
kansas city
I’ve looked and pinouts for the accord but I can’t find any for the f20B distributor pin out. Vehicle starts up and runs, just throwing a CEL for that code. Driving me nuts lol
 
Back
Top