Installed Sidemarkers

Just did this today, came out cleeaaaaann!

Sorry bad angles - tight garage.

good job

you did them yourself?

Good job

I want to put a set on my jeep

Yeah dude, just took a few hours in the morning and got down and dirty with the dremel. Wasn't sure how to start measuring them, but eventually found some landmarks and when measurements were even on both sides I put down the template. By the way. I created a printable template which measures out mm-to-mm so you can just cut it with scissors and tape it
I just resized it a bunch of times in MSPaint by trial and error until all measurements were printed to be accurate.

Here it is:



This will help those installing EK sidemarkers. Just save it to your desktop, then print it - it should be to scale.

The arrow that is pointing to front, is pointing to the narrower end. I put my sidemarkers wider end to the front, therefore reversed the arrows.

Enjoy

looks good bro, nice job

niceeee.. now dump your car.. please

at least you didn't try to do it with a table knife.


....just trust me.

i think you should have gone with clear side markers, but either way its looks good

Only did one side........

J/K, looks pretty good though. I'm STILL undecided on it, and not sure which sidemarkers I want to go with. Don't want amber ones though. Maybe something black-housed.....there go's my Ebay 'Spidey-sense'.....

Lookin good, but damn, you are like as high as I am!