Alright.
I've got two vehicles. My Accord went down while I was working on my '97 Nissan Sentra.
We've been using our neighbors vehicle for transportation. We are very grateful.
It is quite urgent from our viewpoint to get the Accord finished.:
So much for urgency.
The problem:
I'm hooking everything back up after doing a head job. First time with a Honda, third head job ever.
I took pictures, obviously not enough though.
There is a very large connector (?) located on the harness right by the knock sensor and oil pressure switch connectors.
I can't figure out what goes back into it. Does it have multiple male connectors that mate with the large female? Is it some type of relay or fuse?
Help...
Thanks for consideration and any replies.
I'm gonna' go take a quick shot of the connector (?) in question.
I'll update in a minute.
I've got two vehicles. My Accord went down while I was working on my '97 Nissan Sentra.
We've been using our neighbors vehicle for transportation. We are very grateful.
It is quite urgent from our viewpoint to get the Accord finished.:
So much for urgency.
The problem:
I'm hooking everything back up after doing a head job. First time with a Honda, third head job ever.
I took pictures, obviously not enough though.
There is a very large connector (?) located on the harness right by the knock sensor and oil pressure switch connectors.
I can't figure out what goes back into it. Does it have multiple male connectors that mate with the large female? Is it some type of relay or fuse?
Help...
Thanks for consideration and any replies.
I'm gonna' go take a quick shot of the connector (?) in question.
I'll update in a minute.
Last edited: