juicebox00
Well-Known Member
I'm going to make the simple, short, and sweet.
The set up:
Currently I have a J32A1 swapped into my sedan. The intake manifold if from a J35A4 w/o the spacer, TB is from a J32A2, it is still using the J30A1 4SPD Transmission, J30A1 Engine Harness, and J30A1 ECU.
J32A2 TB not pictured here
The issue:
The cars starts up great and purrs like a kittay. But at 2500rpm there is a huge misfire problem. When I floor it there is no issue and it runs great, but if I ease into the throttle the misfire comes up. The check Engine light will also begin to flash.
Codes:
Throws them in the following order
P0301
P0302
P0303
P0304
P0305
P0306
P0300
On Sunday, Hasan(S13@fullboost) and myself are going to be swapping the J32A1 Harness and a 1999 Acura TL ECU. Ignoring the issue with needing to reflash the ECU to be able to use my keys, is there anything else that could be causing these codes to appear as well as the misfire? Or after the swap on Sunday, should the codes disappear?
Thank you,
Matt
The set up:
Currently I have a J32A1 swapped into my sedan. The intake manifold if from a J35A4 w/o the spacer, TB is from a J32A2, it is still using the J30A1 4SPD Transmission, J30A1 Engine Harness, and J30A1 ECU.
J32A2 TB not pictured here
The issue:
The cars starts up great and purrs like a kittay. But at 2500rpm there is a huge misfire problem. When I floor it there is no issue and it runs great, but if I ease into the throttle the misfire comes up. The check Engine light will also begin to flash.
Codes:
Throws them in the following order
P0301
P0302
P0303
P0304
P0305
P0306
P0300
On Sunday, Hasan(S13@fullboost) and myself are going to be swapping the J32A1 Harness and a 1999 Acura TL ECU. Ignoring the issue with needing to reflash the ECU to be able to use my keys, is there anything else that could be causing these codes to appear as well as the misfire? Or after the swap on Sunday, should the codes disappear?
Thank you,
Matt
Last edited: