wsdrummer06
Well-Known Member
it just every time you post on forums you get the school girl trollers that put in their 2 cents
Will these wheels fit?
- Thread starter wsdrummer06
- Start date
Valet
IS300 SX > Accord
That's usually in threads that were made because the OP either didn't search, is asking something stupid, or is posting about something that already has a designated thread.
You could have gotten a ton of trollers that would all point to The Wheel Fitment Thread. But instead you did get answers and advice.
I don't think everyone on this thread is assholes.
You could have gotten a ton of trollers that would all point to The Wheel Fitment Thread. But instead you did get answers and advice.
I don't think everyone on this thread is assholes.
wsdrummer06
Well-Known Member
My true question is this:
the 17x10 wheels are +25 and the adapters to the 4x108 lug pattern run 1 inch(25.4mm)
therefore im sitting at an even 17x10+0
in the rear ive seen people run 17x10's but idk
will i be screwed?
will a moderate fender roll and 205 tires be enough?
how much camber might i truly need?
p.s. I realise cleansleeper is going to troll on me but im so inbetween without being able to mock it all up!
the 17x10 wheels are +25 and the adapters to the 4x108 lug pattern run 1 inch(25.4mm)
therefore im sitting at an even 17x10+0
in the rear ive seen people run 17x10's but idk
will i be screwed?
will a moderate fender roll and 205 tires be enough?
how much camber might i truly need?
p.s. I realise cleansleeper is going to troll on me but im so inbetween without being able to mock it all up!
truWarier02
Well-Known Member
Moderate fender roll? No. More like widebody to fit 10's with such a low offset.
A borderline slammed 6GA sedan with x9 +20 offset wheels, generally, sits flush with around -4 camber. A x10 +0 offset setup results in about 32mm more poke. Think about that for a second.
wsdrummer06
Well-Known Member
I'm just going to run 17x9 on all corners
i've thought about running some mustang wheels with my accord as well.
more specifically the 03/04 terminator wheels.
But those are 17x9 with a high offset.
I'm assuming your coming from a mustang backround as well wsdrumer.
more specifically the 03/04 terminator wheels.
But those are 17x9 with a high offset.
I'm assuming your coming from a mustang backround as well wsdrumer.
