Wheel Fitment Thread
- Thread starter xci.ed6
- Start date
Valet
IS300 SX > Accord
How low are you?
phi1542
Well-Known Member
Would 215/40 f 225/40 r work for 18x8.5 +30 f 18x9.5 +35 r? Or would 205 f 215 r be better?
kn0x47
Senior Member
^^this is a 18x8 +26 with a 215/40
phi1542
Well-Known Member
^^this is a 18x8 +26 with a 215/40
Damn that looks clean lol I might just go 18x8.5 +30 all around with 205 or 215/40 because im not a fan of different size wheels haha I only see the wheels sold in different sizes though online. Maybe a wheel shop around me can get it for me. some reason it bothers me if its not the same xD with my wheels being a bit wider and a little higher offset would still look like that? And what do you think about 225/40 on 8.5s o.o because i found some kumho tires in 225/40 with 600 tread wear. I just want a tire that will last long and has decent drivability.
Last edited:
Looking to buy varrstoen es7 18x9.5 in the front 10.5 in the rear + 22 offset , would this be able to fit and what adjustments other than camber would i have to do? My car is already very low about an inch off the ground. Right now im running 17x7.5 i still need to roll my fenders and buy a kit. wanting to run 215/40/18s for some stretch just need some more facts about what needs done.
White6GAV6
Well-Known Member
Roll, pull, relocate bumper tabs and camber.
Last edited:
xKevo
Active Member
I got some new (used) wheels that came with tires. 18x9 +25 with 235/35/18. what do you guys think? Never seen those numbers around here. I'm lowered on FF1 with a 2 finger gap, I'll probably go a little lower when Spring comes back around to maybe a finger gap or a little less than that. It's my daily and I want a pretty flush fitment. Fenders aren't rolled yet but will be. 2 of the tires are pretty shot and the other 2 are still good. I'd rather just replace the 2 honestly that are bad. Should I just stick to 235/35 so it can stay the same all around or can I go skinnier on just 2 tires?
Last edited:
truWarier02
Well-Known Member
I suggest getting a set of 215/40 and eliminating all wheel gap or 23.5" fender-to-ground. Relocate rear bumper tab too.
hondatech03
Well-Known Member
I have my finder lips rolled and a drop of -1.9f and -1.75r
I plan to get pf01s in 17x8.5 + 40 et. I want the tires to be flush with the wheel and a one finger gap between the tire and fender. What size tire do I need?
I plan to get pf01s in 17x8.5 + 40 et. I want the tires to be flush with the wheel and a one finger gap between the tire and fender. What size tire do I need?
