jaz
Well-Known Member
not sure if this is the place but anyways.. i was ATTEMPTING to put new rotors on my friends car, the caliper came off no problem but then i noticed that the 2 screws holding the rotor on were STRIPPED.. how the heck can i get these stripped screws out? should i drill them out? and just not replace them or are they necessary
Installed rotors, now they make literally a fart noise when he breaks really hard, is that due to over tightened calipers? thanks
Installed rotors, now they make literally a fart noise when he breaks really hard, is that due to over tightened calipers? thanks
Last edited: