Dyi LED trunk light upgrade

I was not going to do this but what the hell. This is to make your trunk bright as day.

Parts needed:

Wire, I think mine was 14ga
3 or 4 led strips, one of mine is alpena other 2 are cobb
Heat shrink
Zap straps
E tape

These are the lights I got from ebay for 10 bucks




Here's the link

http://www.ebay.ca/itm/141984909039...49&var=441104411205&ssPageName=STRK:MEBIDX:IT

So find the oem trunk light and remove it and unplug, I cut off the connector
Looks like this


There is tabs on the side u gotta push them in



So on mine white is ground and orange is hot
Check on your with power tester

Next mount your leds. I put 1 on each side and 1 in the middle. Run all your wires to the center where the trunk light wires are, try to hide them as best you can my pass side was a *****. Make sure they are secured good.

Here's how I ran my sides and where I installed them. They came with 2 way tape.



This is my center one I installed before


Wiring
Pass side


Driver is up here


Meet them up with the oem harness. Solder and heat shrink them up, make sure you test everything before soldering.


Final product





For this I used a bunch of scrap wire and whitish leds, you can use any color to match your car. Any questions feel free to ask.

Pros
Bright
Looks killer

Cons
Now I see how dirty my trunk really is

Looks good, repped and added to DIY master list.

Nice, always appreciate seeing some well done lighting mods.

Needs more subs.

Holy shiit, that is a bright idea, I had to rep ya. GJ man.

Thanks bud.