RedRyder
Save the manuals
It's a black plastic/rubber strip about 1/4" thick that goes along the top edge of the lip. It is not taped to the car, it is angled from the factory so when pressed up against the bumper cover the pressure alone creates a seal. As for how it is attached to the lip itself, not sure but I think it is attached with some sort of adhesive.
If you want to see photos of anything specifically, I can take some for you.
It runs the whole length of the lip at the rear
And just the parts that come in contact with the bumper on the front
If you want to see photos of anything specifically, I can take some for you.
It runs the whole length of the lip at the rear
And just the parts that come in contact with the bumper on the front
Last edited: