I know this is an old thread, but really need help. I have a 2000 accord 4 cyl 2 door ex leather, Ive done a complete engine rebuid and while it was out, the old clutch line needed replaced and so did the slave cylinder, Well i ordered a stainless steel line for it with the same fittings on my old lin and went to put it on and the new slave cylinder has just the hole for the 3 an flare made to slide in and lock with pin, my factory line is threaded and so was the master and slave cylinder, but have looked everywhere and they dont offer a diff slave
cyl.
My new line threads to the master cylinder just fine, both ends on my line are 12mmx 1.0, just have the problem on the slave cyl, my accord dont have the quick disconnect, they are both threaded. Thanks if anyone could throw their input in.