Russianred
Snail Spools You!
Bump for Ken! 
FS: NASOHC Parts For Sale... See Page One!!!
- Thread starter NASOHC
- Start date
Still got that stock exhaust if you want itand my stock block too
Thanks but car's basically done now. Just going to schedule with body shop now to repaint bumpers, front lip and repair minor quarter panel dent.
Just looking to sell engine long block now. I did get an exhaust afterall from wrecking yard for $40
Oh =/ Wish I could afford it right now, but for some reason I have a feeling that the swap would cost me a bunch. That, and I don't have an ECU to go with it haha. I don't think the stock one would do too much good.
So, basically the only thing I have left over to sell is:
F23A1 VTEC Motor (longblock)
SPECS:
Wiseco (-5cc) Forged Piston Kit, 86.5mm Bore
KaizenSpeed Balance Shaft Remove kit
Cylinder Head, ported to match OEM gasket, 237cfm flow tested
Bisimoto Spring kit
Bisimoto Cam, Level 2, NA
Balanced Crank
Oil pump attached
Oil Pan Included
Valve Cover Included
Cam Gear Included
Looking to sell complete!!! Less than 12k miles on it. Runs super strong. Broken in using Torco TBO oil, dyno'd with zero miles by Bisimoto Engineering. Ran on 5w-30 Synthetic Oil 100% of the time. Does not smoke, runs clean!
Dyno'd at 174whp/172wtq on AEM EMS - that's about 200bhp/tq average!!!
SMOKIN' DEAL!!! ONLY ASKING: $500 Cash or PayPal
Do the math, I spent well over $1000 in parts alone - not incl. machine work and engine core (which is actually the "original" block and head that came off my 6th Gen car)
F23A1 VTEC Motor (longblock)
SPECS:
Wiseco (-5cc) Forged Piston Kit, 86.5mm Bore
KaizenSpeed Balance Shaft Remove kit
Cylinder Head, ported to match OEM gasket, 237cfm flow tested
Bisimoto Spring kit
Bisimoto Cam, Level 2, NA
Balanced Crank
Oil pump attached
Oil Pan Included
Valve Cover Included
Cam Gear Included
Looking to sell complete!!! Less than 12k miles on it. Runs super strong. Broken in using Torco TBO oil, dyno'd with zero miles by Bisimoto Engineering. Ran on 5w-30 Synthetic Oil 100% of the time. Does not smoke, runs clean!
Dyno'd at 174whp/172wtq on AEM EMS - that's about 200bhp/tq average!!!
SMOKIN' DEAL!!! ONLY ASKING: $500 Cash or PayPal
Do the math, I spent well over $1000 in parts alone - not incl. machine work and engine core (which is actually the "original" block and head that came off my 6th Gen car)
Last edited:
