IBoughtAnAccord
Member
- Joined
- Jan 6, 2015
- Posts
- 8
- Reaction score
- 0
So in August 2015, I did the driver front wheel bearing with a Honda bearing. I changed the bearing and had the shop press in the new one. When the mechanic pressed in the new bearing, he pressed along the center race, not sure if this caused an issue but I know the outer is the one to be used. It was not packed with grease as I saw grease packed in already so I assume Honda(Koyo) put enough.
I changed the oil yesterday and while up, I did a check and the wheel is shaking again. It has 9-3 minimal movement but none 6-12. I have about 15,000 miles on this bearing, what could cause it to be bad?
I held the wheel, pushed the tie rod in and out and had no play and the steering does not feel as if it has excessive play.
Can the bearing be bad this quickly?
I changed the oil yesterday and while up, I did a check and the wheel is shaking again. It has 9-3 minimal movement but none 6-12. I have about 15,000 miles on this bearing, what could cause it to be bad?
I held the wheel, pushed the tie rod in and out and had no play and the steering does not feel as if it has excessive play.
Can the bearing be bad this quickly?