ok so I installed an amp and sub in a 6th gen Accord today and here:
1. connected the power to the battery with the inline fuse and connected to the amp *check*
2. remote wire connected to the blue with white line behind the deck *check*
3. rca connected to the (sw) outputs at rear of deck *check*
4. rca connected to the amp *check*
5. ground cable bolted to the seat belt bolt *check*
6. ground connected to the amp *check*
7. speaker wires connected (check)
now, the problem is when all connected as previously stated above the amp does not even light up (has a led that shows power is on)
But, when i disconnect one of the rca plugs and just touch the amp case I get power and random bass......????wtf
this system/set up used to work on a previous car the only diff's are the wires.
-could it be the rca cables?
fyi. its a 2channel amp and a single 12inch sub JL
thanks for any advice
1. connected the power to the battery with the inline fuse and connected to the amp *check*
2. remote wire connected to the blue with white line behind the deck *check*
3. rca connected to the (sw) outputs at rear of deck *check*
4. rca connected to the amp *check*
5. ground cable bolted to the seat belt bolt *check*
6. ground connected to the amp *check*
7. speaker wires connected (check)
now, the problem is when all connected as previously stated above the amp does not even light up (has a led that shows power is on)
But, when i disconnect one of the rca plugs and just touch the amp case I get power and random bass......????wtf
this system/set up used to work on a previous car the only diff's are the wires.
-could it be the rca cables?
fyi. its a 2channel amp and a single 12inch sub JL
thanks for any advice