TitaniumACC
Well-Known Member
1. Pry the clock bezel from the center intrument panel (pry on the top and bottom, not from left to right).
2. Pull the clock bezel out enough to disconnect the connector for clock and hazard switch.
3. Detach the retaining screws from the trim panel. There is one at the top in the clock bezel cavity and two at the bottom. The remainder of the panel fasterners are clips. Pry carefully on the panel until the clips are disengaged.
4. The A/C and heater control is attached to the center intrument panel by screws on the back. Pull the panel away from the dashboard enough to disconnect the two connectors at the heater controls and remove the panel.
5. Remove the radio trim bezel.
6. Remove the retaining screws and pull the radio outward to access the electrical connectors and the antenna lead and lift the radio out.
2. Pull the clock bezel out enough to disconnect the connector for clock and hazard switch.
3. Detach the retaining screws from the trim panel. There is one at the top in the clock bezel cavity and two at the bottom. The remainder of the panel fasterners are clips. Pry carefully on the panel until the clips are disengaged.
4. The A/C and heater control is attached to the center intrument panel by screws on the back. Pull the panel away from the dashboard enough to disconnect the two connectors at the heater controls and remove the panel.
5. Remove the radio trim bezel.
6. Remove the retaining screws and pull the radio outward to access the electrical connectors and the antenna lead and lift the radio out.
