K24a4

highway_patrol · Nov 28, 2006

Don't know if this is in the right place.
Here is a link to an auction for a K24A4 out of a 2005 Accord.
Thought I'd post it for anybody who might be adventurous, esspecially since its only 800 buy it now.

http://cgi.ebay.com/ebaymotors/K-se...5QQihZ006QQcategoryZ33615QQrdZ1QQcmdZViewItem

ryan s · Nov 28, 2006

do any 6spd trannies bolt to the k24? my mind is completely blank...

Jeffro · Nov 29, 2006

Y? You could get a 5-speed easy as pie :thumbsup:

A 6-speed for a 4 banger would be much more of a challenge IMO...

highway_patrol · Nov 29, 2006

I heard somewhere that Prototype racing had taken a K24 put F22C crank to destroke it to 90.7mm, sleeved it to 90mm. Those mods I know for sure but I think they also put a K20A2 head on which puts around 240hp. There are a couple problems with this setup though. The first being the obvious, where are you going to get an F22C crank. The K20A2 head isn't as hard but still involves a little searching. Last if I remember correctly, it revs to 9400 which means all the power is up high which is bad for us accord owners. Anyways heres a link to the TSX Acurazine site where there is a link to a vid of this engine swapped into a Lotus Exige vs a stock Exige.

http://tsx.acurazine.com/forums/printthread.php?t=29759

BlkCurrantKord · Nov 29, 2006

"The TSX engine-trans will require a completely new set of engine mounts unless a K20A trans is used, then it's just one that needs to be changed."

The only 6spd K trannies out there.