Cluster Problem HELP!

yo44boichris · May 17, 2011

so I was changing out my ground wires to 0 gauge ones. When I got done, my cluster arrow for my rpm some how fell below the 0 like its just hanging down. When I turn on the car it moves up, but something is blocking it from going up, so it says at 0 the whole time. I don't know how it got below that marker, what should I do...?

CG6Lemon · May 17, 2011

you know there's a thing that prevents it from dropping to a certain point right? the little thing that the rpm needle sits on. did you take off your cluster when changing out the wires?

yo44boichris · May 17, 2011

^^ yess that thing! its not sitting right. I didn't take out anything it just fell.....

CG6Lemon · May 17, 2011

so are you saying your rpm needle is under the plastic thing that prevents it from jumping back up? if yes then you're gonna need to take off the cluster to fix it. the rpm needle can spin backwards back to the top again. you will have to shake it somehow to spin back to it's original position.

yo44boichris · May 17, 2011

hmm alright ill give it a try.

yo44boichris · May 17, 2011

how do you take a out the cluster! i took the black trim but now I'm at removing the cluster it self

G'sAccord01 · May 17, 2011

to take my cluster out i had to take apart the plastic around the steering wheel bcaz ontop of the steering wheel behind a plastic flap thing theres 2 more screws