V6 5 stud hub conversion

[6thgenaussie]

Hey everyone, i have the 4cylinder year 2000 model accord sedan, and i want to convert it to 5 stud, using V6 accord parts of similar year.
Am i correct in thinking that for the rear, I can just bolt up the whole V6, Hub, brake assembly by just connecting the rear arms and hooking up the brakes etc.??

And for the front, What is required, Can i do the same? Do the V6 drive shafts have the same Spline? Therefore allowing me to use My original drive shafts in the New 5 stud hub?

Any info much appreciated, Cheers eveyone

 

[Valet]

Search around a little bit This has been covered many times.

 

[ShaGGy21]

search please ..
http://www.6thgenaccord.com/forums/showthread.php?t=7337&highlight=DIY+Lug+Swap

 

[6thgenaussie]

i appreciate that, thanks allot, i did try search though, not well enough obviously, Thanks allot for your replys, Love this honda its such a nice cruisin car. I really want Euro 17's on it but i got a set of the 16's for $150 brand new never used so i will put those on and go with it. Also have two Skylines, A 180sx and two aussie ae86's if anyones interested. Thanks allot im going to read this DIY thread, i May have some questions so bare with me. Cheers !