Search results

  1. M

    I tried rebuilding my trans, somethings wrong...

    So I just finished rebuilding the transmission (MAXA) by myself. I thought I did well, I guess not, I have no clue. I ran it for a little bit in the air, but things felt horrible when I tried to take it into gear. When I put it into reverse, it feels like there is a terrible wobble, right after...
  2. M

    Auto Trans Rebuild Concerns

    I’m doing my first rebuild. When removing the 3 nuts from the main gear shafts, I confused which one was left hand threaded. So basically I torqued all of them down instead of unscrewing them. My impact gun goes up to 700 ft-lb…. I turned each nut about 15-30 degrees. Should I be concerned I may...
  3. M

    Tranny Problems..

    It started when I was driving all day, I made a stop, and turned off the engine. Three minutes later I got back to my car and drove off, instantly I had problems. It seemed like (I’m am no expert in automatic trannys) when it was shifting, it disengaged the first gear and wouldn’t engage the...
  4. M

    What's your average MPG???

    Wow you guys get a lot! Chicago traffic.... 18-21 MPG..... 4cyl
  5. M

    New upper control arm bushing squeak!

    So two years ago I replaced my upper control arms for some cheap ones of TASAUTO. They worked alright for a few weeks and started squeaking really bad. I put up with it. This summer I couldn't stand it anymore and purchased MOOG aftermarket UCA's. It was quiet for two weeks... First the...
  6. M

    ECM swap advice

    P1607 is the CEL I receive on really cold days. From what I read It means I need a new ECM. I have a F23A1 EX SEDAN. Im assuming getting an ECM from a COUPE shouldn't cause problems so long as its same engine and trans? An ECM from a F23A4 is no go? What other factors should I look...
  7. M

    Keyless entry problems

    Thanks! All four actuators?! or can one bad one disturb the functionality of all others? Sorry im a noob at the whole lock systems
  8. M

    Keyless entry problems

    I was wondering if anyone had some insight on what could be the faulty part. Wanted to have some clue before digging in and stripping of the door panels. So when I press lock or unlock, all the doors will make a sound as if they were attempting follow the command yet they are all stuck. same...
  9. M

    Are my struts bad? or something else

    The one thing i did fail to mention is that the rubber boot around the strut is damaged. I can see the inside of the strut, the boot basically hangs there. I left this out because honestly its been like this for sometime, and i wanted to see if the problem could be something else because i...
  10. M

    Are my struts bad? or something else

    Heres a vidio of the noise it makes http://www.youtube.com/watch?v=fQO54ysF-xM&feature=plcp The noise is produced when i drive straight or even when i get out of my car.Theres no play in my wheel. I installed brand new upper control arms last year that a bought from tas auto. I took a crowbar...
  11. M

    Whats Wrong? (video)

    so it wouldn't be the upper control arms or anything like that?
  12. M

    Whats Wrong? (video)

    http://s833.photobucket.com/albums/zz259/marcinpl90/?action=view&current=MVI_1480.mp4 it makes a noise and you can slightly wiggle it while its in the air? can hear a little noise while driving but it sounds different. what would need to be replaced?
  13. M

    ignition timing

    so basically what i did was line up the notches and i kid you not, on mine the arrow on my block is around 15 deg to the right... maybe that's wrong some how!???!?! but i will definitely do the TDC test with the dipstick. thanks!!
  14. M

    ignition timing

    ok, ill double check tomorrow, ill post pic's , but i'm sure i put it on right.
  15. M

    ignition timing

    long story... mainly because i just switch the timing belt. and before i took the old belt of i left pen/marks so i can put it all back together the way i found it. but these marks as i found out actually didn't line up with the actual marks/ notches on the engine it self. i decide to do it...
  16. M

    ignition timing

    i was searching all over! how do we do this? i have the 4 cylinder and i have no bolt on the distributor to twist it. does it work different then most Honda's?
  17. M

    Timing Belt and Water Pump chage problem...

    haha i had it lifted like 1 cm up, i didn't expect it to shoot out so much. my belt is fine tho most of the oil went on the other side. so do you think that's the only thing that would cause this lack of response?
  18. M

    Timing Belt and Water Pump chage problem...

    yay! so i finished =) everything is aligned, tensioned and well. its great driving normally, but it feels as if when i drive aggressively, it feels less responsive. the rpms take time to get up there, and starts feel slower. then again i haven't driven in a while so its all maybe just a...
  19. M

    Timing Belt and Water Pump chage problem...

    my balancing shaft belt was skipping not my timing. would the balance belt skipping cause damage or just vibrations?
  20. M

    Timing Belt and Water Pump chage problem...

    OK i finally had a chance do do something =) (been in school and work for the past two days, just took bus there) so i may have mistaken the rear balance shafte with the water pump. :doh: the water pump is a little further up hehe. so ill get that replace soon. oh mines a four cylinder by the...
  21. M

    Timing Belt and Water Pump chage problem...

    ugh... making it short, i was taking it apart everything was going smooth, until i got a chance to look at my water pump. it seems the water pump i bought from TAS (did any one else have this problem?)isn't the same as the one on my car. so i drove to the honda dealership, just to find it...
  22. M

    yes or no on this intake?

    i wanna do that... any down side?
  23. M

    Most awesome video ever

    F'ing SWEET!!! :omgbd:
  24. M

    Timing belt & water pump

    I'll take a look at it but will most likely switch it this summer anyway. So, i should strictly use Unitta or would the ContiTech be fine? http://www.statracing.com/oem-replacement/wizard.asp?eng=F23A1,4&cha=CG___&year=1999&make=HO&model=ACC-EX4-003&category=A&part=Timing+Belt+Kit
  25. M

    Timing belt & water pump

    :skurred: i should probably change mine i'm at 98K idk if previous owner swapped it...

Latest posts

Random media

1810.jpg
2012 04 28 18.37.14
6930.jpg
IMG_20201214_121204[1]
had to repaint and do the body work after a hail sotrm
Back
Top