Search results

  1. puzzlemaster94

    98 with 3.0 question.

    About 99% sure its a main relay. Up under the steering column. There is a way to check too. If you've driven the car and go inside a store for a bit and then come back out and its warmish outside, it'll do it. I grabbed a cold water bottle and held it next to it for a minute or so and it...
  2. puzzlemaster94

    New Transmission on the way.

    You've got two trans mounts. Both on the drivers side down low. At least my 99 Did. The front motor mount also sort of acts as a trans mount also. But mine were gone when I pulled mine out.
  3. puzzlemaster94

    Derek's 2002 Coupe EX (5MT)

    Re: phi1542's 02 Coupe 5-Speed Oh. Well that I don't know. Sent from my iPhone using Tapatalk
  4. puzzlemaster94

    Derek's 2002 Coupe EX (5MT)

    Re: phi1542's 02 Coupe 5-Speed Clean the dipstick really well and then run your finger down the dipstick until you feel oil. Its sometimes hard to see. I had this issue on my daily driver the other day
  5. puzzlemaster94

    UPDATED: Evan's Quest for a J32 6MT 6GA

    Re: UPDATED with Wiring Issues: Evan's Quest for a J32 6MT 6GA That's the only thing I didn't replace while the motor was out. I won't be surprised if its out. But its easy to get to. On another topic, my sensor came in. Plugged it in to see if it just needed to read voltage, no...
  6. puzzlemaster94

    Jon's 99 5spd EX Coupe

    Looking for those myself too
  7. puzzlemaster94

    Jon's 99 5spd EX Coupe

    Just had to happen to the lip kit that is near impossible to find. I'll be on the lookout for you
  8. puzzlemaster94

    UPDATED: Evan's Quest for a J32 6MT 6GA

    Re: UPDATED with Wiring Issues: Evan's Quest for a J32 6MT 6GA I've got continuity. Both from the ECU and the gauge cluster. I had the ECU wire crimped into a connector from the gauge cluster. Nothing, this was when I drove it home. Then I tied the wires together from the gauge cluster...
  9. puzzlemaster94

    UPDATED: Evan's Quest for a J32 6MT 6GA

    Re: UPDATED with Wiring Issues: Evan's Quest for a J32 6MT 6GA Alright, I'll check this out and report back Sent from my iPhone using Tapatalk
  10. puzzlemaster94

    UPDATED: Evan's Quest for a J32 6MT 6GA

    Re: UPDATED with Wiring Issues: Evan's Quest for a J32 6MT 6GA Thanks man. How is yours going? Also, I still can't temp to read on the cluster. Anyone have any help here. #14 wire from the CL Plug to the cluster on the temp wire there is what I have.
  11. puzzlemaster94

    UPDATED: Evan's Quest for a J32 6MT 6GA

    Re: UPDATED with Wiring Issues: Evan's Quest for a J32 6MT 6GA Figured I go ahead and update this because of the lack of posts: First off, it still doesn't rev over 2,000. So bummer there. Took the crankshaft pulley off, timing covers, belt and front cam gear off. Replaced the front cam gear...
  12. puzzlemaster94

    Accord V6 5 lug swap

    In regards to decide what to do with the J30: 1.) If you plan on making power with it, just stop now. They sound good with I/H/E and thats about it. These are really not made to hold or make power. They are tanks though, just don't try to make a lot of power on them. I had mine for 225K, 75k...
  13. puzzlemaster94

    What? New aftermarket headlights...

    I've seen these in Accord groups on Facebook here recently. Some don't look too bad
  14. puzzlemaster94

    Wheel Fitment Thread

    Oh, even stiffer than the Tein's. You shouldn't rub with them at all.
  15. puzzlemaster94

    Wheel Fitment Thread

    You are on Teins, you should be fine. I dropped my Teins all the way down on my TL's and never rubbed on them. Even when I had 235/45's on them.
  16. puzzlemaster94

    What'd you do to your accord today?

    Mine did this driving home from the garage where it was. I'm still saying crank sensor on my end, but I did get an O2 code. How far could you rev it up when this happened? I've got those wires left out also, because your wiring diagram told me that you didn't use them. I guess I could try...
  17. puzzlemaster94

    What'd you do to your accord today?

    I've driven way too many E30s not to own one. I really don't know why I don't have one yet lol Sent from my iPhone using Tapatalk
  18. puzzlemaster94

    UPDATED: Evan's Quest for a J32 6MT 6GA

    Re: UPDATED with Wiring Issues: Evan's Quest for a J32 6MT 6GA Updated first page with better breakdown of parts and reasons I used them. Will have to update again as soon as I figure out the part numbers and the rest of the stuff I used.
  19. puzzlemaster94

    What'd you do to your accord today?

    Basically changed the timing belt on the J32 today, pulled it off and on different times, changed my front cam gear, pulled the crankshaft sensor and all that wiring. All while the motor was in the car on all of the mounts. I'm happy you can work around most of the stuff to get to what you need...
  20. puzzlemaster94

    UPDATED: Evan's Quest for a J32 6MT 6GA

    Re: UPDATED with Wiring Issues: Evan's Quest for a J32 6MT 6GA Worked on the car to try to figure out the issues. Started by taking all the timing covers off, then the crank sensor. Tested the sensor and the wiring harness to the sensor, and they are both fine. Did find a bit of dirt in there...
  21. puzzlemaster94

    Varnell's '99 J37 Stroker 6MT Coupe EX-L

    Dont tempt me with these 300whp goals. I should probably get mine running first lol. By the way, thank you for all of your help so far
  22. puzzlemaster94

    UPDATED: Evan's Quest for a J32 6MT 6GA

    Re: UPDATED with Wiring Issues: Evan's Quest for a J32 6MT 6GA So I pulled the code and it's for the crankshaft position sensor, which is behind the timing covers and the crankshaft pulley. Get all that off, while the motor is in the car, and it's a brand new sensor, manual pulley, timing belt...
  23. puzzlemaster94

    What'd you do to your accord today?

    You know who needs a set of set skirts....... Good to see you are back, would like to see this TL. Sent from my iPhone using Tapatalk
  24. puzzlemaster94

    PuzzleMaster94's J32 6MT 1999 Accord EX-L V6 Coupe (56k)

    Updated first page. The J32 is now in the car and is moving under its own power, but having issues. I discuss it further in my swap thread. It's good to see this swap done, but needs to be able to run properly
  25. puzzlemaster94

    UPDATED: Evan's Quest for a J32 6MT 6GA

    Re: UPDATED with Wiring Issues: Evan's Quest for a J32 6MT 6GA So the motor and trans are in the car and move under their own power. But I'm having issues: 1.) So I welded a stud on the shift linkage to prevent the gears being backward, but when I drove it, the gears were backward. Like...

Latest posts

Random media

IMG 1050
image
Stock.
3526.jpg
Eclipse Wheels
Back
Top