Search results

  1. A

    F23 auto ecu options

    have you tried an aem fic.
  2. A

    AEM series 2 EMS ... airbags

    The aem ems does not control the functions of the srs system. Inside the car you will find another control box that similar to the oem ecu that controls the air bags.
  3. A

    Boost

    Okay thanks.
  4. A

    Boost

    Hello all. Given a highly qualified tuner and all minimum parts. A t3t40e on 17lbs f23 block. Will the connecting rods hold for 2years. The pistons are cp. but everything else is stock all oem and newly assembled.
  5. A

    12 sec accord

    All of my suspension is in great condition. Just changed out most parts this past summer. My clutch is an FX300. I think it should hold. The engine is semi built lol. CP pistons, block guard, arp head studs, all new bearings, and factory parts. I'd like to put in an lsd but I hate to go back...
  6. A

    12 sec accord

    Hello, Has anyone been able to get there accord to high 12's in a 1/4mile. Will an accord with new tires t3/t4e turbo running 15lbs of boost work at the minimum. I know there are enhancements like lsd, shocks, etc., but will the above work.
  7. A

    boost

    Sounds good. Will definitely boost on it till next summer when I put in forged rods. :boink:
  8. A

    boost

    Simply question. Will F23 connecting rods hold up to 15lbs of boost on a t3/t4e turbo for a maximum of 2 years reliably. :manos:
  9. A

    aem ems 1050 v1

    solved my own problem today. Base ignition wasn't set even after the tuner said so. Car drives great under boost but at idle sucked for gas mileage. After adjusting idle is close to 14.1 - 14.7. Thanks.
  10. A

    aem ems 1050 v1

    So I'm trying to figure out how to get my aem to idle at 14.7 without going lean do to(power steering, lights, or a/c). I've played with the settings(ac) and I'm at 11.6-12.2 during idle. If anyone is running 1050 v1 or 6050 v2, what is your afr at idle.:doh:
  11. A

    F23 rods

    Does anyone know what the max torque you would run on stock f23 connecting rods? I've heard some people say that you can boost up to 300 torque on stock rods with no problem. I'm just wondering what is the limit safely without needing to upgrade.
  12. A

    aem v1

    So as it turns out the tuner didn't know the aem. I had to get another tuner that normally turns subaru's. He got me started and I got home safely.:Moon: The car still has a few problems though. The car dies alot once its started from a cold start. After its warmed upon it runs good. I have to...
  13. A

    aem v1

    Thanks for all the responses. The problem was definitely the tuner. For the aem v1 the start-up cal on the aem 1050 doesn't start the vehicle right off like it is suppose to. The cam and crank signals had to be properly set in order for the car to start and fire correctly.:hahano:
  14. A

    aem v1

    Anybody have problems with the aem v1 1050 not picking up the crank signal on an f23a1 manual? I'm seriously considering the aem v2 6050. Car is at the tuner and he's t/s.:confused:
  15. A

    Hey you had any joy on shipping the f23 harness this week

    Hey you had any joy on shipping the f23 harness this week
  16. A

    Hey, any luck on that f23 mt harness by or for this weekend. thanks

    Hey, any luck on that f23 mt harness by or for this weekend. thanks
  17. A

    Battery indicator

    So this weekend I tried a few suggestions but I'm still stumbled. All lights in car work as well as outside lights. I'm getting intermediate full priming. When turninig the car to the on position the fuel primps then stops quickly than it should. It goes off as soon as the battery indicator goes...
  18. A

    Battery indicator

    Hi Problems with my 01 Honda accord. Mods 5 speed swap Currently my car will not crank over. It displays no cels but a battery/alt indicator. I have installed two new batteries, two new alternators, and one new starter on the car for testing purposes with no joy. I also have doubled...
  19. A

    DIY: Automatic to Manual Transmission Swap

    thats exactly the side I needed. I messed up big. Ill fix it some how.
  20. A

    DIY: Automatic to Manual Transmission Swap

    On the transmission plug You said "locate the big tranny plug in the engine bay. find the grey and red wire on the plug. strip and solder these 2 wires together." ON the same plug: what would be the color of the wires be on the other side of the plug connected to the harness. On my accord I...
  21. A

    DIY: Automatic to Manual Transmission Swap

    Help, I read the article for auto to 5 speed. I have a problem with the wiring. What are the colors on the other side of the plug to the transmission.:wtf1:
  22. A

    Help, I read the article for auto to 5 speed. I have a problem with the wiring. What are the...

    Help, I read the article for auto to 5 speed. I have a problem with the wiring. What are the colors on the other side of the plug to the transmission.
  23. A

    aem help

    after looking at the wiring, there is a big bifference. A16 which is the fuel pump relay for the 1050 is not used on the automatic A16. There are also about 8 other so pins that are different. When I get off I will double check everything including the 2001 honda accord ex pinout that I have...
  24. A

    aem help

    So I recently got a hold of an AEM EMS 1050 for my turbocharged car. The car was swapped over from an auto to 5 speed. The problem that I'm having is the fuel pump wont come on. I followed all steps to the 5 speed DIY. When I put in the automatic ecu it comes on. No joy for the 1050 though. What...
  25. A

    obd2 to obd1

    I'm still new to this thread. So what is needed to convert an 01 honda accord auto obd2 to 01 honda accord manual obd1?

Latest posts

Random media

2861.jpg
4114.jpg
Now that's a clean car :)!!!!!!
2192.jpg
Rear WHITE
Back
Top