Search results

  1. S

    Rear speakers hit trunk spring.

    I took my springs out and just hold my trunk up.
  2. S

    Blew A Headgasket!!

    Great numbers! Is there a link of your build/setup?
  3. S

    Axle Nut?!....

    I just use a big breaker bar and a 3ft cheater bar.
  4. S

    New Injectors

    Unless you have modded your engine to require extra fuel you should just get your factory ones cleaned.
  5. S

    Axle Nut?!....

    It's normal right hand thread. Did you knock out the little punch that locks the nut on? When you install a new nut you punch in two spots that lock it in place.
  6. S

    f23 build

    Just be patient and it'll pay off. If you stop now all your hard work will be for nothing. Keep us updated!
  7. S

    Hand-brake light stays on while driving

    I'm willing to bet it's that filter in your brake reservoir. I had this same thing happen to me and I just replaced that filter and everything has been good since.
  8. S

    maxbore TB and boost

    I highly doubt boost pressure would cause a crack in a TB. The only time I've ever seen a cracked throttle body was when someone over tightened the T-bolt clamp for their charge pipe. You can put some serious pressure with those clamps.
  9. S

    maxbore TB and boost

    It really depends on your final power goals. If you're going to try to get every ounce of power then go with "D". If you're looking to hit around 350-400 hp than I would just stick with stock.
  10. S

    Cruise Contril NOT WORKING.

    Check your vacuum lines that control the cruise control. Mine fell off once and it didn't work at all.
  11. S

    This is gonna be a funny thread

    Not in my 6th gen, but a spider freaked me out and I ended up driving up a curb while trying to get it off of me.
  12. S

    How much "piston slap" is too much when starting cold? Advice Please!

    Piston slap should be very minimal (0 - 10 seconds) in factory engines. It's more common with after market forged pistons that require a little heat expansion to fill the sleeve.
  13. S

    geeks only

    This a great starter program that I'm sure can grow into something very useful. Add features like density of different materials, coefficients of friction and some basic dimensioning ability will make it an actually easy to use dynamic simulator. Very geeky but I've learned to live with the...
  14. S

    Snowboarding

    I've been addicted to skiing for 3 years now, but I'll have to give snowboarding a try this year. Anyone here do both? Why so many snowboarders lately?
  15. S

    if u were never hooked.....

    Skiing and travel.
  16. S

    f23 build

    Damn, I was hoping to see your final numbers today.
  17. S

    Turboing high mileage F23a4?

    Buy a helms manual for the 6th gen accord. It's an expensive book, but trust me with the electrical manual and the mechanical manual you'll be able to rip anything apart. Here is my build to help you out a little... http://www.everything-honda.com/forums/showthread.php?t=3679
  18. S

    Redtoy's next major project..and probably the last!

    The extra lag you'll get from the taller intercooler won't be that bad. And your 200hp goals are easily achievable. Good luck.
  19. S

    Turbo!!!

    Just my two cents... Get a turbo that matches your driving needs/likes. If you like low end power get a fast spooling turbo. It doesn't matter if it spools before vtec or not. Once everything is said and done you should tune your car to have smooth power throughout your power band. No...
  20. S

    F23a4: trans. swap before turbo or vice-versa?

    If you're going for all out performance you should pick up a H series trans. The gears are shorter for better acceleration and it's well supported for aftermarket LSD. Here is a break down of cost. This is a complete ESTIMATE. -F series trans and parts 600.00 -H series trans and parts 900.00...
  21. S

    F23a4: trans. swap before turbo or vice-versa?

    I ran stock motor and auto trans with turbo for well over two years just fine then did a full build and 5spd swap. If I were to do it all over again I would do the 5spd swap first since that doesn't have a chance to destroy anything. I drove very cautiously when I was still an auto. Good luck.
  22. S

    Redtoy's next major project..and probably the last!

    Specs?
  23. S

    PLEASE comment on mah friend's resume

    You can definitely shorten it down. I was part of a group hiring people for Lockheed Martin and the first thing we did was toss out any resume over a single page. We weren't trying to be asses, but you have to remember there were over 1000 resumes for 3 people to read. If you want PM me and...
  24. S

    Rear disc question

    Hey, can I have dibs on your rear disc stuff if accordc1 doesn't take it?
  25. S

    Turbo!!!

    T3/To4e 57trim with 63 AR hot side here. Put down 365hp at 17-18 psi.

Latest posts

Random media

5784.jpg
Si and cuz's Altima
Driver's Seat
257.jpg
image
Back
Top