Budget Retro Project

Discussion in 'DIY - Do It Yourself Forum' started by agginline86, Apr 1, 2014.

Car Parts
  1. Silver99

    Silver99 Well-Known Member

    Age:
    23
    Posts:
    91
    Likes Received:
    2
    Joined:
    Sep 29, 2015
    Location:
    US
    I'm using these projectors, but did anyone have to dremel out the back housing to make them fit? I think that mine are hitting the lens. I haven't fully assembled them but when I put the buckets against the blackhoused area/lens I'm thinking it hits. Will that change when I fully assemble them? Thanks
     
  2. Jordan_H

    Jordan_H Well-Known Member

    Posts:
    807
    Likes Received:
    3
    Joined:
    Aug 4, 2013
    Location:
    Washington State
    I did not have that issue. You must be doing something else wrong. Maybe the rubber helmet you're using is not correct
     
  3. Caliaccord02

    Caliaccord02 Well-Known Member

    Age:
    29
    Posts:
    200
    Likes Received:
    6
    Joined:
    Feb 22, 2013
    Location:
    California
    By buckets do you mean shrouds? If so on mine I had to cut a piece out of each shroud in order for them to fit against the blackhousing. Here is the video I used...go to 10:25 on the video.
    https://youtu.be/AIVJWd9WLB4
     
  4. Jordan_H

    Jordan_H Well-Known Member

    Posts:
    807
    Likes Received:
    3
    Joined:
    Aug 4, 2013
    Location:
    Washington State
    It would make more sense if he's talking about the housing rather than the lens.
     
  5. Silver99

    Silver99 Well-Known Member

    Age:
    23
    Posts:
    91
    Likes Received:
    2
    Joined:
    Sep 29, 2015
    Location:
    US
    I was talking about the area where you put the bulb. I will mount then all the way and see. I cut the shrouds and made sure everything was seated all the way, but it may just be because I don't have them fully assembled. Thank you for the video, I will check it out.
     
  6. Silver99

    Silver99 Well-Known Member

    Age:
    23
    Posts:
    91
    Likes Received:
    2
    Joined:
    Sep 29, 2015
    Location:
    US
    I'm also not using any rubber helmet
     

Share This Page