clutch line dilemma

Discussion in 'Engine & Transmission Mods' started by 2pac, May 27, 2019.

  1. 2pac

    2pac Member

    Posts:
    6
    Likes Received:
    0
    Joined:
    Feb 2, 2019
    Location:
    israel
    hello
    does the stock cluth line have the same diameter on botn ends?
    and what to do if i got a stock m/c and a prelude slave which has a thinner inlet? i want to get a ss braided line.
    thanks
     
  2. Eclipse99fwb

    Eclipse99fwb Well-Known Member

    Posts:
    174
    Likes Received:
    6
    Joined:
    May 15, 2016
    Location:
    Aurora CO
    Should be the same, even if you have a prelude slave. If its not for some reason than getting a used accord slave would be your cheapest route. Not sure what you are referring too with a ss braided line, most of the line is metal tubing. That and trust me you wont see any performance gain, better off getting ss lines for your brakes. Hope this helps.
     

Share This Page