RedRyder
Save the manuals
TL skirts look good, just need painted. Are they OEM? I know the TL OEM lip kit is hard to find.
gben_qc stanced gold sedan
- Thread starter gben_qc
- Start date
White6GAV6
Well-Known Member
interested in how the skid plate was made as well, like the material and thickness, i just ordered another set of coilovers so i should probably make one
He used 1/4in aluminum. Mine is is made out of 3/16th aluminum. I'm going to 1/4 steel next because aluminum is kind of pointless. Steel is a bit heavier, but a lot stronger.
gben_qc
Active Member
I use 1/4 aluminium cause i think if it was tinner it will bent. I dont get steel cause it make sparke and cops hate stanced car over here. I don't have picture but gonna take one next oil change.
Yes it's tls oem side skirt i had to cut them in the rear about 1 inch to fit perfectly with the cg chassis. All clip are at the same place. I found them in a junk yard and pay 10$ for them they where in mint condition.
danmccormick87
Well-Known Member
Looks awesome and hmmmm, the side skirts are close by to me, might try this out 
Loving the two tone look you are going for also 
Loving the two tone look you are going for also
gben_qc
Active Member
Looks awesome and hmmmm, the side skirts are close by to me, might try this out
The 2 tone came with the dx model and i like the way it looks. It's look different to other who are 1 color
Keepnitorganic
Member
Clean car, gold and black look sick together.
gben_qc
Active Member
Thanks a lot everyone! Right now i'm looking to get a teflon 1/8 plate to install under the skid plate to remove noise and go more low cause teflon can slip on ground.
PlowingLeaves!
Well-Known Member
Brad2274
Well-Known Member
wondering that too, i looked up teflon sheets and damn that stuff is pricey, isnt it the same stuff as those plastic cutting boards and sheets you lay down when cutting out stencils and stuff? i feel like there has to be a cheaper good solution
