Wiring DRL

[Dnguyen211]

Hey community I was wondering if this wiring procedure I just thought up would work to make DRLs. So if I just used the normal high beam bulbs and connectors but I wired it up to where there is a wire on either side of the car such as one wire for each bulb, then I connect the wire to the positive of the connector and put a diode then a resistor on it and put it to ignition positive? So it would go a little like this.... Positive from ignition>resistor>diode>twisted in with positive of high beam connector>bulb

 

[james'99]

I did it with two relays, an add a fuse, an inline fuse, and connectors. Did an add a fuse to the sunroof fuse. That was the trigger for relay 1. Then, wired relay 2 to be triggered off by the low beams coming on but its power supply came through relay 1. I ran the two bulbs in series to cut the voltage in half. Make sense?

 

[Dnguyen211]

I did it with two relays, an add a fuse, an inline fuse, and connectors. Did an add a fuse to the sunroof fuse. That was the trigger for relay 1. Then, wired relay 2 to be triggered off by the low beams coming on but its power supply came through relay 1. I ran the two bulbs in series to cut the voltage in half. Make sense?

Honestly not completely

 

[Dnguyen211]

Bump

 

[james'99]

Tomorrow night, I will draw up a diagram for you.

 

[FNCONE]

Hamsar DRL relay is what i used diagrams can be found online

 

[Dnguyen211]

Tomorrow night, I will draw up a diagram for you.

Thank you

 

[Dnguyen211]

Hamsar DRL relay is what i used diagrams can be found online

Could you link me to the diagram and the product please

 

[james'99]

I drew it. Can you give me an email address so I can send you that?

 

[Dnguyen211]

[email protected]