99CcordMTF23
Well-Known Member
So, the cg5 is making me angry. I am sick of it acting up so I figured now would be the perfect Time to just build up the motor.
Question time. How well do you think a set of eagle H beams, and a set of 86mm je pistons for a k20a3 would work out in the f23 block? The pistons I was looking at were 11:1 compression. And the rods are a like two millimeters shorter. So I have no idea what compression that would yield. As far as the block, I'm Pretty sure the f23 has iron walls. That's how it looked last time I was In there. Because eventually it will get some boost. Until then I want an unbreakable fully forged and balanced monster(not) but I never want to worry about a piston again. Lol any ideas, tips, ect would be appreciated. My info was obtained from the sticky info thread.
Side question. Someone said you can boost an accord with an apexi vafc and make it work? I call bull****... Any info?
Thank you guys.
Question time. How well do you think a set of eagle H beams, and a set of 86mm je pistons for a k20a3 would work out in the f23 block? The pistons I was looking at were 11:1 compression. And the rods are a like two millimeters shorter. So I have no idea what compression that would yield. As far as the block, I'm Pretty sure the f23 has iron walls. That's how it looked last time I was In there. Because eventually it will get some boost. Until then I want an unbreakable fully forged and balanced monster(not) but I never want to worry about a piston again. Lol any ideas, tips, ect would be appreciated. My info was obtained from the sticky info thread.
Side question. Someone said you can boost an accord with an apexi vafc and make it work? I call bull****... Any info?
Thank you guys.
Last edited: