Recent content by ferron
-
F
Tips on Clutch Master Clynder Removal & Install
Sorry to revive and old thread I'm replacing my CMC and everything else was easy except this clutch hose connector is giving me hell any suggestion?- ferron
- Post #20
- Forum: Engine & Transmission Mods
-
F
Pic(s) of Tein Basis with 17s?
My car was on 18's in the sig on basics.- ferron
- Post #11
- Forum: Suspension, Brakes, Wheels, and Tires
-
F
New Addition to the Fam. [[56k]]
I havent driven the sh awd but im really shocked by this one it moves along pretty well especially when i drive it with the shift paddles. I ruled out the awd because it cuts your trunk space down with the differential. Im telling you go test drive one I think you'd be suprised. -
F
New Addition to the Fam. [[56k]]
Thanks man I liked this one because the beak and the rear was redesigned when I seen this one I was gonna get white but the graphite is nice when its clean its dirty in the pics ill post more pics after i get it tinted. -
F
New Addition to the Fam. [[56k]]
Thanks Put half down so payments aren't bad at all, and yes I still have the green one. That's about to be under construction. Also, I have a little boy now its all about the warranty and peace of mind when we take family trips goes somewhere with him. not slamming this one....yet lol... -
F
New Addition to the Fam. [[56k]]
The tranny went in my other car. ('99 V6 Accord Coupe) And I didn't feel like dealing with it so I went out and bought this. 2012 Acura TL. -
F
Shake/rotor warping issues
Not sure it seems more likely that the aftermarket wheels a weight could have fallen off but I really don't see the stock wheels i just put wheels on and had balanced and aligned recently being out. I think it lies deeper than that when it gets warmer unless something else happens. I plan on...- ferron
- Post #15
- Forum: Accord Tech
-
F
Shake/rotor warping issues
replaced bearings already and i did compress the caliper you have too with new pads.- ferron
- Post #10
- Forum: Accord Tech
-
F
Shake/rotor warping issues
They actually are autozone duralast rotors. And i have the autozone cmax pads on them. I had to put new brake calipers on because it was dragging so bad it made on side almost 300 degrees hotter than the other. I don't seem to have any play in the wheels themselves.- ferron
- Post #7
- Forum: Accord Tech
-
F
Shake/rotor warping issues
just had it in the air and everything seemed to be good. Sometimes it does under acceleration. I cant seem to tell with hard acceleration. I will say if i drive it and its cold it seems shake the whole time until it warms up.- ferron
- Post #3
- Forum: Accord Tech
-
F
Shake/rotor warping issues
So my car seems to keep warping rotors even though I dont ride them or make high speed stops. Also I have a constant shake it seems to be around 55-60mph but sometimes appears at lower speeds just put back on stock wheels and new tires. It also did it when I had the old ones on, so I'm not...- ferron
- Thread
- Replies: 16
- Forum: Accord Tech
-
F
What'd you do to your accord today?
Got stock wheels powdercoated and put on with two new tires on them. Now it looks kinda wierd.- ferron
- Post #2,841
- Forum: General Chat
