http://postimg.org/image/n9759byip/
After washing away all the grime from the slave cylinder, I noticed a difference in the visible hole. With further inspection, I found the "pin" that needed to be hammered out.
I used a flat nail and a hammer to remove it, carefully making sure I didn't...
http://postimg.org/image/79k2y8gqj/
I can't seem to take off the fitting from the old slave cylinder.
I've searched in the forums, and the only other post I saw that was relatively close, didn't show the steps to remove it. The OP just stated that he drilled the remove the connector...