Slave Cylinder "Fitting/Connector" Assistance

JohnBeard · Mar 11, 2015

I can't seem to take off the fitting from the old slave cylinder.

I've searched in the forums, and the only other post I saw that was relatively close, didn't show the steps to remove it. The OP just stated that he drilled the remove the connector.

http://www.6thgenaccord.com/forums/showthread.php?t=48953&highlight=slave+cylinder

I didn't notice any visible pins in or around the area when i removed the slave cylinder either.

Any assistance or guidance would be greatly appreciated.

xci.ed6 · Mar 11, 2015

the mounts point up, th hose connects near the bleeder...
what's the pin for? I can not remember a pin, maybe only 98-02 Accords have it?

JohnBeard · Mar 11, 2015

http://postimg.org/image/n9759byip/

After washing away all the grime from the slave cylinder, I noticed a difference in the visible hole. With further inspection, I found the "pin" that needed to be hammered out.
I used a flat nail and a hammer to remove it, carefully making sure I didn't break it.

It was a perfect fit on the new slave cylinder and the job is complete.