Search results

  1. B

    Looking for sway bars and strut tower

    Not true. I auto-x my car and it makes a difference. Maybe it won't for you when you use your car to pick up groceries. I also have the UR 4 point middle under car brace which helped a lot also.
  2. B

    Upper Control Arm(UCA) interchangeability?

    Truhart parts are just hardrace parts rebranded as truhart. I just purchased toe arms, camber arms, and UCA bushings from hardrace. I ordered all pillow ball bushings. They also offer rubber and hardened rubber.
  3. B

    Looking for sway bars and strut tower

    I think my setup is the best. Eibach front sway bar, progress rear sway bar, Fastline performance adjustable endlinks(I can corner balance), and comptech titanium strut bar. You could also run a 2nd gen cl-s or tl-s strut bar plus the neuspeeed strut bar.
  4. B

    Interest In Custom Rear Control Arms

    I am sorry if I am somewhat hijacking your thread, but [I] thought some ppl might be interested. The tsx UCA will bolt up to the 6th gen accord. They will throw off the castor though. That is what a company said. They didn't get anymore specific. Why would you want to buy and install 6th...
  5. B

    My J32/6 speed quest!

    The reason aem made it for auto motor only is because they made it specifically for j swaps in civics and integras. They don't care about the cl or accord. Most ppl buy an auto engine because there are so many of them. Only 3000 some 6 speed cls were made, versus probably 50,000 automatics...
  6. B

    Car shakes when I start it?

    My rpm's start high 900-1000 then drop down to 750-800.
  7. B

    Moonroof drain r&r

    I think the cl trunk issues has to do with either the rear windshield seal or that channel right below it. I believe they use sealant there and over time it can wear down and crack. Then water can get inside.
  8. B

    Moonroof drain r&r

    I have removed the whole moonroof assembly from my car and made a sunroof panel. I did it to remove 30lbs from my car. I also removed the 4 drain tubes. One goes to each corner of the vehicle. You will need to remove stuff to get at them. My car was already gutted for autocross. I...
  9. B

    Upper Control Arm(UCA) interchangeability?

    Re: UCA interchangeability? I remember someone emailed a company that makes front camber arms for 03-08 tsx. The company said that the arms would bolt up, but they throw the caster off. The clip is also in a different location. If you try it out I would be interested in results.
  10. B

    What is cheap way to make your car as quiet as much as possible?

    Do what I did. Gut the interior, scrape off all the sound deadening, remove cat and mufflers, then throw on some sticky tires.
  11. B

    Parents won't let me mod

    Lol at the part about if your opinion is different than mine then don't post and get out. Must be nice to be in high school and think you know everything when in reality you know nothing.
  12. B

    Carbon Fiber Hood Problems

    I stopped reading after 2 seconds because of the horrible grammar.
  13. B

    Will 4cyl catback fit v6

    Seems kind of silly to me to modify an exhaust to fit when you can just have a custom one built.
  14. B

    Noise from road debris?

    I must be the only one who likes to feel and hear everything going on with their cars. I only really notice the road debris on the road I live on that is covered in rocks. I only noticed it really when switching to sticky tires. It does not matter how fast you go . Even going 5 mph you...
  15. B

    Fixed Sunroof suggestions

    I made a sunroof panel out of lexan and used metal brackets to hold it in place.
  16. B

    My J32A2/6MT -> 2001 V6 Accord Swap Thread

    Was the donor cl wrecked? If not, I feel sorry for that car. Only 3000 were made in manual and not many left. I bought my 03cls6 new in 2002. I would rather use a cl shell over an accord shell.
  17. B

    1998-2002 Accord Suspension List

    I don't see my coilovers listed. Zeal function T I want to get the koni 2812's next.
  18. B

    Noise from road debris?

    My car is the same way. I removed all my interior and sound deadening and am running sticky star spec tires. My car is probably worse than yours, but it doesn't really bother me at all.
  19. B

    Interest In Custom Rear Control Arms

    Nice work. Thnx for offering these. I will definitely buy 1 or 2 sets.
  20. B

    DIY: sunroof plug & intake heat shield

    I made a sunroof panel for my car. I used metal brackets from Home Depot/lowes and made the panel out of high grade scratch resistant tinted lexan. For the seam you can seal it with silicone or use a rubber weather seal. The route you are taking will require welding and paint, whereas my...
  21. B

    Lowering with wide 9.5 rims? (pic)

    Get wheels that fit. I can't wait for this silly stanced wheel/ stretched tire fad to wear off.
  22. B

    02 Accord Upgrading Tires

    You need to give more info than just 17" wheels. What width are the wheels and offset. Are you wanting more traction, better fuel mileage, etc.? Go to 1010tires.com and use their tire calculator. To decide what tires to use I would recommend going to tirerack and reading reviews/comparisons.
  23. B

    Anybody use "TRUHART"

    I have seen truhart camber arms advertised in hondatuning mag a lot. Seems like a legit company to me.
  24. B

    Endlink Question(s)

    I am using the Fastline performance adjustable end links, but they cost more than 99 percent of people are willing to spend. I autocross my car so it is nice to have the adjustability for lowering a car and corner balancing it. You could make your own end links for pretty cheap if you...
  25. B

    Upper control arm brands

    If you need more adjustment than stock provides Just go with ingalls or spc and replace the boots with oem honda boots. Problem solved. If you don't need more adjustment then just buy oem honda. The honda bushings and boots are better quality than aftermarket. All the aftermarket dust...
Back
Top