,

[jaz]

not sure if this is the place but anyways.. i was ATTEMPTING to put new rotors on my friends car, the caliper came off no problem but then i noticed that the 2 screws holding the rotor on were STRIPPED.. how the heck can i get these stripped screws out? should i drill them out? and just not replace them or are they necessary


Installed rotors, now they make literally a fart noise when he breaks really hard, is that due to over tightened calipers? thanks

 

[Sketch o5]

Re: Rotor help

those screws dont really matter. dont worry about them.

 

[jaz]

Re: Rotor help

ive never used an impact screw driver before, would it get a stripped screw out? or should i drill

 

[JMillerUA6]

Re: Rotor help

Drill them out.

 

[jaz]

Re: Rotor help

ok drill it is, thanks fellers

 

[Sketch o5]

Re: Rotor help

oohh, i read it wrong, hahahaha. yea, drill them out for sure.

 

[DarkSideAccord]

Re: Rotor help

when u put the new rotors on, u dun need to put those screws on

 

[dtraill27]

Re: Rotor help

those screws are a bitch i had to use heat to get the stripped ones out. didnt put them back in

 

[HondaLuver83]

Re: Rotor help

Drill them out, but you should make sure and use a "grab it tool". It makes life easier.

 

[jaz]

Re: Rotor help

ok thanks guys