Doesn't want to run

[Dnguyen211]

So this morning I had started my car a little before leaving to go to the store, I had it started for at least 5 mins before I even tried to put it in gear and this happened... I put it in D4 and no light, also when I hit the gas it wouldn't move unless I hit it hard and it would barely move, threw it into D3 and same thing just the light worked though, D2 is a little better but still had a problem, D1 was alright at first but it didn't really want to go very fast unless I beat it... I only have 2 CEL codes, one is the P1607 and the other was just a o2 sensor heater circuit... I don't like this one bit, please help!

 

[RedRyder]

What is the other code? Secondary sensor?

 

[Dnguyen211]

What is the other code? Secondary sensor?

It's P0141 for the bank 1 sensor 2

 

[james'99]

The broken heater circuit is fine for now. Whatever. Won't cause limp mode. At least as long as other codes aren't thrown in the meantime. P1607 is a PCM failure of sorts though. Check out this thread...

http://www.6thgenaccord.com/forums/showthread.php?t=39940

 

[Dnguyen211]

Bump it is 28 degrees outside and it did it again

 

[james'99]

Bump it is 28 degrees outside and it did it again

Did you ever try erasing that code to see if it comes back?

 

[Dnguyen211]

Did you ever try erasing that code to see if it comes back?

Not yet but I found if I let the car warm up then shut it off and turn it back on its out of "limp mode"

 

[xci.ed6]

Yeah, clear the codes, see what comes back.

Circuit boards can be effected by temp.

 

[Dnguyen211]

So this morning I got sick of the problem and I was sure I had no other check engine lights and the code to which tripped it was p1607 so now I am sure that code is the problem

 

[rooky]

Damn bro you fix one problem then another appear, sounds like my car I swear.