help needed with speaker wiring

[krylonking104]

Im going to be running three pairs of 4 ohm MB Quartz speakers (1 pair of FKA116 and 2 pairs of FTA169) as well as some infinity reference tweeters (with crossover) to an eclipse 2 CH amp (PA4212)- 200W RMS x 2 at 2 ohms and 130W RMS x 2 at 4 ohms....

Could anyone provide a wiring diagram or some sort of rationale as to how i should go about wiring these up? preferably wired so that my amp would see a 2 ohm load (for maximum power).



Thanks a bunch!

 

[botang47]

im not sure if its possible in this case. anyway i can think of wiring 3 speakers to one channel will create a load less than 2 ohms. unless they were 8 ohm speakers (which i dont even think they make), you could get a 2.7 ohm load.