J32 Swap with AT... What do I need?

[WeaponX20]

My transmission just shat out on me and I don't have the money to do a 5spd swap so I'm pretty much stuck with getting a temp AT. I figured that since I'm pulling the tranny out I should upgrade my engine, because somewhere down the road I want to either put a Dr. Evil in the car or do a 5Spd swap.

I managed to find this:
http://www.torontojdm.com/cart.php?target=product&product_id=4360&category_id=120

And I'm interested in getting it, I just want to know what else I'll need to buy in order to make it work. Or will it just bolt up no problem?

Thanks in advance guys

 

[LX_F23A1]

if you have a 4cyl, and your trying to go for a v6 swap in the same engine bay, your better off getting a whole v6 accord.

 

[WeaponX20]

No she's a v6, i just replaced the motor and transmission mounts too, is there anything i need?

 

[WeaponX20]

bump

 

[JapCrap]

Try a search or look in the same forum on the same page that you posted a new thread.....I found this link on the same page of your thread....

http://www.6thgenaccord.com/forums/showthread.php?t=33365

 

[WHEEELMAN]

Might want to post this up on V6performance.net for some definite answers.


looks like its just going to be a J32A1 swap, which SHOULD be able to mount on the Accord chassis.

J30A1 ECU could run it, but I would not go wide open throttle cause the J30A1 ECU maps are not going to match the J32A1 setup.


**since it's JDM, I'm not sure about the differences, if any.